For joining traditional (silver) mirrors on all types of surfaces.

Close container properly and store in a dry, cool and frost-freeplace.

One cartridge issues approx. 8-15 metres of adhesive (depending on the diameter of the cut nozzle).

Apply the adhesive in vertical stripes (possible moisture behind the mirror can not run away if there are horizontal adhesive stripes) every 20 cm on the back of the undamaged mirror. Mount the mirror within 10 minutes and press firmly. The space behind the mirror must be well ventilated and remain so. Support large mirrors 24 hour using a ruler or tape until the adhesive has completely cured.

Cut off screw thread, assemble nozzle and cut to a diameter of at least 0.5 cm.

Do not apply the adhesive by circular movement, but in vertical stripes. Sufficient air must be able to reach the adhesive.

Before using open cartridge at the top by cutting off the plastic nipple above the thread with a sharp knife. Then fix the nozzle and cut at an angle (opening at least Ø 5 mm).

Use white spirit for cleaning tools and removing wet adhesive residue. Dry adhesive residue can only be removed mechanically.

Both parts must be solid, clean, free of dust and grease. Use of primer not required. The surface may be slightly moist.

Apply cartridge contents using a sealant gun.

Only apply at temperatures between +5 °C and +40 °C.