Suitable for applying all types of light, medium and heavy wallpaper, including paper, simplex, duplex and acrylic wallpaper.

Ready-made paste remains workable for several days when stored tightly sealed.

Close container properly and store in a dry, cool and frost-free place.

Prepare or mix with water.

Add the powder in small quantities to cold water while vigorously stirring until a lump-free paste is obtained. Stir up the paste again vigorously after 15 minutes. The paste is now ready to use. Coat thoroughly and evenly, making sure the edges are properly covered. Fold the strips double and allow the paste to soak in. Press the seams well, possibly by means of a roller. Always hang wallpaper in accordance with the manufacturer's instructions. Ready-made paste remains workable for several days when stored tightly sealed.

See table

Always hang wallpaper in accordance with the manufacturer's instructions.

Remove the old wallpaper using a wallpaper removal agent, then clean the surfaces in order to remove any remaining paste, grease or dust. Fill holes and cracks with wall filler to make the surface even and then coat any stains so that they do not show on the surface of the wallpaper. Prime highly absorbent surfaces first with diluted wallpapering paste (20 % water). Allow this primer layer to dry for at least 2 hours. Sand non-absorbent surfaces (e.g. latex layer) by initially opening up and then making the surface dust-free.

Mixing ratios Pre-paste: water (6 L), coverage: ±50 M² Light (paper): water (5 L), coverage: 25-45 M², 5-7 rolls Normal (paper): water (4 L): coverage: 20-25 M², 4-5 rolls Heavy (vinyl, jute): water (3 L): coverage: 20-25 M², 4-5 rolls Water temperature: 5 -10°C

Remove traces of paste immediately by dabbing with a clean, dry cloth. Dried paste on the surface of the wallpaper can be removed by dabbing with a clean, damp cloth.

For an optimal result the surface must be porous, solid, clean, permanently dry, smooth, dust- and grease-free.

Pasting brush, bucket, stirring stick, wallpaper table. Clean tools immediately after use with water.

Do not apply at temperatures below +10 °C and/or relative humidity higher than 70 %.